The stress in tendons of bonded beams is: – McqOptions

MCQOPTIONS

1.	The stress in tendons of bonded beams is:
A.	‚âà√≠¬¨¬±<sub>e</sub> (My/I)
B.	‚âà√≠¬¨¬±<sub>e</sub> (My/R)
C.	‚âà√≠¬¨¬±<sub>e</sub> (My/L)
D.	‚âà√≠¬¨¬±<sub>e</sub> (My/20)
Answer» B. ‚âà√≠¬¨¬±<sub>e</sub> (My/R)

Discussion

No Comment Found

Related MCQs

Which beams are preferred mostly due to their higher flexural strength?
The development of crack widths is comparatively larger in ____________
The rate of increase of stress is larger in case of ____________
The stress in tendons of bonded beams is ____________
A prestressed concrete beam used over a span of 6m is 100mm wide and 300mm deep, live load of 4kn/m, density of concrete is 24kn/m3, modulus of elasticity of concrete is 36 and steel is 210kn/mm2. Find rotation due to loads(sagging moment)?
The rate of increase in stress in the tendons of a prestress concrete member depends upon ____________
In the elastic range, any increase in prestressed member does not show any effect on ____________
The cross section of a prestressed concrete beam is 100mm wide and 300mm deep and the initial stress in tendons are located at a eccentricity of 50mm is 1000n/mm2, the sectional area is 100mm2. Find rotation due to prestress (hogging moment)?
The rotation equation obtained by applying Mohr’s theorem considering a concrete beam of span l, force p, eccentricity e is?
The prestressed member undergoes deformation due to the action of ______________