The same signal in Problem 2 is applied to an RC high-pass filter. If – McqOptions

MCQOPTIONS

1.	The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero at the input frequency, the output voltage is____________?
A.	12.73 V peak-to-peak
B.	18 V peak-to-peak
C.	9 V peak-to-peak
D.	zero
Answer» C. 9 V peak-to-peak

Discussion

No Comment Found

Related MCQs

Vout = 500 mV, and Vin = 1.3 V. The ratio Vout/ Vin expressed in dB is__________?
The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero at the input frequency, the output voltage is____________?
The maximum output voltage of a certain low-pass filter is 15 V. The output voltage at the critical frequency is_____________?
In a series resonant band-pass filter, a lower value of Q results in______________?
In a certain parallel resonant band-pass filter, the resonant frequency is 14 kHz. If the bandwidth is 4 kHz, the lower frequency_____________?
In a certain low-pass filter, fc = 3.5 kHz.if the input voltage is a 6 V sine wave with a dc level of 10 V, what is the output voltage magnitude?
In a certain low-pass filter, fc = 3.5 kHz. Its passband is____________?
In a certain low-pass filter, fc = 3.5 kHz. Its pass-band is_______________?
At a certain frequency, the output voltage of a filter is 6 V and the input is 12 V.the filter’s bandwidth is____________?
At a certain frequency, the output voltage of a filter is 6 V and the input is 12 V. The voltage ratio in decibels is_____________?