The ratio of the maximum deflections of a simply supported beam with a central load W and of a cantilever of same length and with a load W at its free end, is

The ratio of the maximum deflections of a simply supported beam with a

1.	The ratio of the maximum deflections of a simply supported beam with a central load W and of a cantilever of same length and with a load W at its free end, is
A.	1/8
B.	1/10
C.	1/12
D.	1/16
Answer» E.

Discussion

No Comment Found

Related MCQs

In a shaft, the shear stress is not directly proportional to%!
Pick up the incorrect statement from the following: The torsional resistance of a shaft is directly proportional to%!
The general expression for the B.M. of a beam of length l is the beam carries M = (wl/2) x ‚Äö√Ñ√¨ (wx¬¨‚â§/2)%!
The maximum bending moment for a simply supported beam with a uniformly distributed load w/unit length, is%!
*$_Inertia of a rectangular section of width and depth about an axis passing the moment of through C.G. and parallel to its width is?
*$_A simply supported beam carries varying load from zero at one end and w at the other end. If the length of the beam is a, the maximum bending moment will be?
*$_For the close coil helical spring of the maximum deflection is?
*$_A bar L metre long and having its area of cross-section A, is subjected to a gradually applied tensile load W. The strain energy stored in the bar is?
*$_For determining the support reactions at A and B of a three hinged arch, points B and Care joined and produced to intersect the load line at D and a line parallel to the load line through A at D‚Äö√Ñ√¥. Distances AD, DD‚Äö√Ñ√¥ and AD‚Äö√Ñ√¥ when measured were 4 cm, 3 cm and 5 cm respectively. The angle between the reactions at A and B is?
*$_A spring of mean radius 40 mm contains 8 action coils of steel (N = 80000 N/mm¬¨‚â§), 4 mm in diameter. The clearance between the coils being 1 mm when unloaded, the minimum compressive load to remove the clearance, is?

The ratio of the maximum deflections of a simply supported beam with a central load W and of a cantilever of same length and with a load W at its free end, is

Discussion

No Comment Found

Related MCQs

Reply to Comment