The ratio of the cutting force to the cross-sectional area being cut i – McqOptions

MCQOPTIONS

1.	The ratio of the cutting force to the cross-sectional area being cut is called:
A.	specific cutting force
B.	thrust force
C.	frictional force
D.	none of the mentioned
Answer» B. thrust force

Discussion

No Comment Found

Related MCQs

The ratio of the cutting force to the cross-sectional area being cut is called:
In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal is called:
In metal machining, the zone where the heat is generated due to friction between the moving chip and the tool face is called
Transducers have a much __________ natural frequency and stiffness than dynamometers.
Cutting forces can be measured using a
Which of the following parameters govern the value of the shear angle in continuous chip formation?
In a single point turning tool, the side rake angle and orthogonal rake angle are equal. is the principal cutting edge angle and its range is 00< <900. The chip flows in the orthogonal plane. The value of is closest to