Cutting forces can be measured using a – McqOptions

MCQOPTIONS

1.	Cutting forces can be measured using a
A.	transducer
B.	dynamometer
C.	load cell
D.	all of the mentioned
Answer» E.

Discussion

No Comment Found

Related MCQs

The ratio of the cutting force to the cross-sectional area being cut is called:
In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal is called:
In metal machining, the zone where the heat is generated due to friction between the moving chip and the tool face is called
Transducers have a much __________ natural frequency and stiffness than dynamometers.
Cutting forces can be measured using a
Which of the following parameters govern the value of the shear angle in continuous chip formation?
In a single point turning tool, the side rake angle and orthogonal rake angle are equal. is the principal cutting edge angle and its range is 00< <900. The chip flows in the orthogonal plane. The value of is closest to