The problem with the single operational difference amplifier is its – McqOptions

MCQOPTIONS

1.	The problem with the single operational difference amplifier is its
A.	High input resistance
B.	Low input resistance
C.	Low output resistance
D.	None of the mentioned
Answer» C. Low output resistance

Discussion

No Comment Found

Related MCQs

Determine the voltage gain for the given circuit known that R1 = R3 = 10kΩ abd R2 = R4 = 100kΩ.
For the difference amplifier shown below, let all the resistors be 10kΩ ± x%. The expression for the worst-case common-mode gain is
For the circuit given below determine the input common mode resistance.
For the difference amplifier as shown in the figure show that if each resistor has a tolerance of ±100 ε % (i.e., for, say, a 5% resistor, ε = 0.05) then the worst-case CMRR is given approximately by (given K = R2/R1 = R4/R3)
If for an amplifier v1 and v2 are the input signals, vc and vd represent the common mode and differential signals respectively, then the expression for CMRR (Common Mode Rejection Ratio) isa) 20 log (|Ad| / |Ac|)b) -10 log (|Ac| / |Ad
If for an amplifier the common mode input signal is vc, the differential signal id vd and Ac and Ad represent common mode gain and differential gain respectively, then the output voltage v0 is given by
The problem with the single operational difference amplifier is its
If for an amplifier v<sub>1</sub> and v<sub>2</sub> are the input signals, v<sub>c</sub> and v<sub>d</sub> represent the common mode and differential signals respectively, then the expression for CMRR (Common Mode Rejection Ratio) is
If for an amplifier the common mode input signal is v<sub>c</sub>, the differential signal id v<sub>d</sub> and A<sub>c</sub> and A<sub>d</sub> represent common mode gain and differential gain respectively, then the output voltage v<sub>0</sub> is given by
For the difference amplifier which of the following is true?