The primary disadvantage of the flash analog-to digital converter (ADC – McqOptions

MCQOPTIONS

1.	The primary disadvantage of the flash analog-to digital converter (ADC) is that:
A.	it requires the input voltage to be applied to the inputs simultaneously
B.	a long conversion time is required
C.	a large number of output lines is required to simultaneously decode the input voltage
D.	a large number of comparators is required to represent a reasonable sized binary number
Answer» E.

Discussion

No Comment Found

Related MCQs

A binary-weighted digital-to-analog converter has a feedback resistor, R, of 12 k. If 50 A of current is through the resistor, the voltage out of the circuit is:
The resolution of a 0–5 V 6-bit digital-to-analog converter (DAC) is:
An 8-bit digital-to-analog converter (DAC) has a resolution of 0.125 V.
A binary-weighted resistor used in a digital-to-analog converter (DAC) is only practical up to a resolution of ________.
The key advantage of the successive approximation analog-to-digital converter (ADC) is its conversion speed.
One way to determine the resolution of a digital-to-analog converter (DAC) is to compare the ratio of one step voltage to the maximum output voltage.
Inaccurate analog-to-digital conversion may be due to ____________.
In a binary-weighted digital-to-analog converter (DAC), the values of the input resistors are chosen to be proportional to the binary weights of the corresponding input bits.
Which is not an analog-to-digital (ADC) conversion error?
A binary-weighted digital-to-analog converter has a feedback resistor, Rf, of 12 k. If 50 A of current is through the resistor, the voltage out of the circuit is: