The number of armature parallel paths in a two-pole D.C. generator hav – McqOptions

MCQOPTIONS

1.	The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is
A.	2
B.	4
C.	6
D.	8
Answer» C. 6

Discussion

No Comment Found

Related MCQs

Which of the following could be lamina-proximately the thickness of laminations of a D.C. machine ?
While applying Fleming's right-hand rule to And the direction of induced e.m.f., the thumb points towards
For a D.C. generator when the number of poles and the number of armature conductors is fixed, then which winding will give the higher e.m.f. ?
In D.C. generators, the brushes on commutator remain in contact with conductors which
If brushes of a D.C. generator are moved in order to bring these brushes in magnetic neutral axis, there will be
If a cable of homogeneous insulation has a maximum stress of 10 kV/mm, then the dielectric strength of insulation should be
The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be
The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage
The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is
The main factor which leads to unstable parallel operation of flat and over compounded generators is