For a D.C. generator when the number of poles and the number of armatu – McqOptions

MCQOPTIONS

1.	For a D.C. generator when the number of poles and the number of armature conductors is fixed, then which winding will give the higher e.m.f. ?
A.	Lap winding
B.	Wave winding
C.	Either of (a) and (b) above
D.	Depends on other features of design
Answer» C. Either of (a) and (b) above

Discussion

No Comment Found

Related MCQs

Which of the following could be lamina-proximately the thickness of laminations of a D.C. machine ?
While applying Fleming's right-hand rule to And the direction of induced e.m.f., the thumb points towards
For a D.C. generator when the number of poles and the number of armature conductors is fixed, then which winding will give the higher e.m.f. ?
In D.C. generators, the brushes on commutator remain in contact with conductors which
If brushes of a D.C. generator are moved in order to bring these brushes in magnetic neutral axis, there will be
If a cable of homogeneous insulation has a maximum stress of 10 kV/mm, then the dielectric strength of insulation should be
The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be
The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage
The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is
The main factor which leads to unstable parallel operation of flat and over compounded generators is