%_The effective height of free standing non-load bearing wall and colu – McqOptions

MCQOPTIONS

1.	%_The effective height of free standing non-load bearing wall and column respectively will be_%
A.	1.0H and 1.0H
B.	1.5H and 1.5H
C.	2.0H and 1.5H
D.	2.0H and 2.0H
Answer» E.

Discussion

No Comment Found

Related MCQs

Water retentivity for brick masonry should not be less than%!
Cement mortars richer than 1 : 3 are not used in masonry because(i) There is no gain in strength of masonry(ii) There is high shrinkage(iii) They are prone to segregation%!
The mode of failure of a very short masonry member having h/t ratio of less than 4 is by%!
The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of%!
Consider the following statements:A high lime content in a composite cement-lime mortar results in1. Slow hardening.2. Quick setting.3. Weaker mortar.%!
Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar.Select your answer based on the codes given below. Codes:%!
Rich cement mortars are more liable to cracking as compared to lean mortars because rich mortars have%!
Assertion A : Lime based mortars give higher ratio of brickwork strength to mortar strength as compared to non-lime mortar.Reason R : Lime based mortars have lower bond strength as compared to non-lime mortars.Select your answer according to the codes given below:%!
*$_Water retentivity for brick masonry should not be less than?
*/*_If ‚Äö√Ñ√≤H‚Äö√Ñ√¥ is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be?