THE_DELAY_IN_SWITCHING_BETWEEN_THE_ON_AND_OFF_STATES_IS_DUE_TO________ – McqOptions

MCQOPTIONS

1.	THE_DELAY_IN_SWITCHING_BETWEEN_THE_ON_AND_OFF_STATES_IS_DUE_TO__________?$
A.	The time required to change amount of excess minority carriers stored in quasi-neutral regions
B.	The time required to change amount of excess majority carriers stored in quasi-neutral regions
C.	The conduction between storage time and recovery time
D.	The exponential increase in carriers in N region
Answer» B. The time required to change amount of excess majority carriers stored in quasi-neutral regions

Discussion

No Comment Found

Related MCQs

The delay time can be reduced by?
The delay in switching between the ON and OFF states is due to _________
A PN junction diode with 100Ω resistor is forward biased such that 100A current flows. If voltage across this combination is instantaneously reversed to 10V at t=0, the reverse current that flows through diode at t=0 is?
The switch is at position shown in the figure initially and steady state is from t=0 to t=to. The switch suddenly is thrown to the other position. The current flowing through the 10K resistor from t=0 is?
In a circuit below, the switch is at position 1 at t<0 and at position 2 when t=0. Assume diode has zero voltage drop and storage time. For 0<t<ts, the VR at 1k ohm resistor is given by_____
Which of the following are true?1) In reverse bias, the diode undergoes stages of storage and transition times2) Minority charge carriers accumulation makes the diode as a short circuit3) Storage time is the sum of recovery and transition times
THE_DELAY_IN_SWITCHING_BETWEEN_THE_ON_AND_OFF_STATES_IS_DUE_TO__________?$
The_delay_time_can_be_reduced_by?$
Time taken for a diode to reach 90% of its final value when switched from steady state is______
Switching speed of P+ junction depends on.