The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is

The bending stress in a wall or column subjected to effective vertical

1.	The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is
A.	ess than or equal to 1/24
B.	ess than or equal to 1/6
C.	ore than 1/24
D.	ess than or equal to 1/12
Answer» B. ess than or equal to 1/6

Discussion

No Comment Found

Related MCQs

A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m . The maximum height of wall from stability consideration is
If the horizontal cross-sectional area of a wall is 1200 cm , then the basic stress shall be multiplied by a reduction factor equal to
Which of the following will give higher ratio of brickwork strength to mortar strength ?
Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load to be resisted may be taken as_______________?
Water retentivity for brick masonry should not be less than__________________?
The use of relatively weak mortar_______________?_x005F_x000D_Consider the following statements._x005F_x000D_1. will accommodate movements due to loads and, cracking if any, and will be distributed as thin hair cracks which are less noticeable or harmful._x005F_x000D_2. will result in reduction of stresses due to differential expansion of masonry units._x005F_x000D_select the correct statements.
The timber floor not spanning on the masonry wall but properly anchored to the wall gives________________?
The thickness of each leaf of a cavity wall shall not be less than_________________?
The mortars used for masonry construction are classified based on strength in IS 2250 and IS 1905 according to their designations L1,L2, H1, H2, M, M2._x005F_x000D_The correct sequence of increasing order of their strengths is?
The mode of failure of a very short masonry member having h/t ratio of less than 4 is by _______________?

The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is

Discussion

No Comment Found

Related MCQs

Reply to Comment