Signal to noise ratio is the preferred metric when ____ – McqOptions

MCQOPTIONS

1.	Signal to noise ratio is the preferred metric when ____
A.	desired signal bandwidth is less than Nyquist bandwidth
B.	desired signal bandwidth is approximately equal to Nyquist bandwidth
C.	desired signal bandwidth is greater than Nyquist bandwidth
D.	bandpass sampling is used
Answer» C. desired signal bandwidth is greater than Nyquist bandwidth

Discussion

No Comment Found

Related MCQs

The point at which the output noise power of the fundamental signal shifts away from the ideal output power by 1-dB is called 1-dB expansion point.
The NPR for an SDR can be determined by matching the radio noise floor to the ADC input noise level.
The sampling rate of promising SDR technology ranges between _____
Which of the following conditions does not affect SNR?
Which of the following metrics is considered for spread spectrum method?
Which of the following applications takes only SFDR as its performance metric?
If Wais the receiver bandwidth and NF is the noise figure, the noise power of a noise limited receiver is given by the expression ____
The ratio of ______ the notch filter to the ____ the notch filter gives the Noise Power Ratio.
Which of the following is the preferred metric when the desired signal bandwidth is less than Nyquist bandwidth?
Signal to noise ratio is the preferred metric when ____