Refer to the given figure. If a solder splash shorted the ends of R1 t – McqOptions

MCQOPTIONS

1.	Refer to the given figure. If a solder splash shorted the ends of R1 to each other,
A.	the op-amp would fail.
B.	Q1 would open.
C.	the output voltage would not change.
D.	the zener would fail.
Answer» E.

Discussion

No Comment Found

Related MCQs

The ________ is (are) an adjustable voltage regulator.
The series 7900 ICs are ________.
The specification sheet for the 7812 fixed positive voltage regulator shows that the output voltage could be as low as ________ or as high as ________.
IC units provide regulation of ________.
Regulator IC units contain the circuitry for the ________.
A type of regulator circuit that is quite popular for its efficient transfer of power to the load is the ________.
In a foldback configuration, limiting the current reduces ________, protecting the load from overcurrent as well as protecting the regulator.
In a current-limiting circuit, ________ provide(s) the limiting of the maximum load current.
The ________ the diode conduction time, the ________ the amount of the charging current through the capacitor filter.
The ________ values of capacitor filter provide ________ ripple and ________ average voltage.