Once a DIAC is conducting, the only way to turn it off is with: – McqOptions

MCQOPTIONS

1.	Once a DIAC is conducting, the only way to turn it off is with:
A.	a positive gate voltage
B.	a negative gate voltage
C.	low-current dropout
D.	breakover
Answer» D. breakover

Discussion

No Comment Found

Related MCQs

<p>Once a DIAC is conducting, the only way to turn it off is with:</p>
<p>Which is the TRIAC?</p>
<p>The DIAC is a:</p>
<p>What type of application would use an injection laser diode?</p>
<p>The serial-in, parallel-out shift register transfers data from one parallel data bus to another parallel data bus one bit at a time across a single line.</p>
<p>A serial-in, serial-out shift register transfers data from one line of a parallel bus to another line one bit at a time.</p>
<p>"Half-splitting" is</p>
<p>If doubling the voltage across a resistor doubles the current through the resistor then</p>
<p>Power supplies are regulated to prevent the output voltage from changing due to changes in the</p>
<p></p><p><img src="/_files/images/basic-electronics/basics/mcq3_1007_1c.gif"></p> <p>What is the power in the given circuit?</p>