Out of the following fuels used in a furnace exhausting flue gas at a – McqOptions

MCQOPTIONS

1.	Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600Â°C, the percentage stack loss will be maximum in case of complete combustion of
A.	furnace oil with air.
B.	furnace oil with oxygen.
C.	blast furnace gas with air.
D.	blast furnace gas with oxygen.
Answer» D. blast furnace gas with oxygen.

Discussion

No Comment Found

Related MCQs

In practical operation of any furnace, zero oxygen percentage or theoretical CO 2 percentage in flue gas is rarely achieved, because of
Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400Â°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200Â°C.
While the fuel fired furnace can be used upto a maximum temperature of about 1700Â°C, the electric furnace can be used upto a temperature of about __________ Â°C.
Presence of SO 2 in furnace gases attacks the ferrous metal by way of
Flue gas outlet temperature from the chimney of any furnace should be ideally about __________ Â°C.
Metallic recuperators are not used for waste heat recovery, if the hot flue gas temperature is above __________ Â°C, because corrosion prevails at higher temperatures.
Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600Â°C, the percentage stack loss will be maximum in case of complete combustion of
In furnaces operating at very high temperature (say) 1250Â°C, e.g. soaking pit), the maximum heat transfer takes place by
Acid dew point temperature (ADT) of a flue gas produced by the combustion of a fuel containing 1% sulphur may be about __________ Â°C.
Which of the following is the most suitable for preheating combustion air above 650Â°C ?