__Maximum slenderness ratio of load bearing walls for a dwelling havin – McqOptions

MCQOPTIONS

1.	__Maximum slenderness ratio of load bearing walls for a dwelling having more than 2 storeys(i) Shall not exceed 12 if lime mortar is used(ii) Shall not exceed 18 if cement lime mortar 1 : 2 : 9 is used(iii) Shall not exceed 24 if cement mortar 1 : 6 is used__
A.	(i) and (ii) are correct
B.	(ii) and (iii) are correct
C.	(i) and (iii) are correct
D.	(i) and (ii) and (iii) are correct
Answer» B. (ii) and (iii) are correct

Discussion

No Comment Found

Related MCQs

Water retentivity for brick masonry should not be less than%!
Cement mortars richer than 1 : 3 are not used in masonry because(i) There is no gain in strength of masonry(ii) There is high shrinkage(iii) They are prone to segregation%!
The mode of failure of a very short masonry member having h/t ratio of less than 4 is by%!
The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of%!
Consider the following statements:A high lime content in a composite cement-lime mortar results in1. Slow hardening.2. Quick setting.3. Weaker mortar.%!
Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar.Select your answer based on the codes given below. Codes:%!
Rich cement mortars are more liable to cracking as compared to lean mortars because rich mortars have%!
Assertion A : Lime based mortars give higher ratio of brickwork strength to mortar strength as compared to non-lime mortar.Reason R : Lime based mortars have lower bond strength as compared to non-lime mortars.Select your answer according to the codes given below:%!
*$_Water retentivity for brick masonry should not be less than?
*/*_If ‚Äö√Ñ√≤H‚Äö√Ñ√¥ is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be?