Knuckle Joint can t be used to connect two intersecting rods. – McqOptions

MCQOPTIONS

1.	Knuckle Joint can t be used to connect two intersecting rods.
A.	Yes
B.	No, it can t be used
C.	It can be used with some modificatios
D.	It is expensive and hence isn t used
Answer» C. It can be used with some modificatios

Discussion

No Comment Found

Related MCQs

If any cross section is subjected to direct tensile stress and bending stress, then find the dimension of cross section. Given length & breadth are t and 2t respectively. F=25kN acts on the top fibre of the cross section, M=F x t . Also maximum allowable tensile stress =100N/mm .
If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods. Given: Max allowable compressive stress=25N/mm , thickness of each eye of fork=25mm.
Calculate the diameter of pin from shear consideration with maximum shear stress allowed is 40NN/mm and an axial tensile force of 50kN is acting on the rod.
Knuckle Joint can t be used to connect two intersecting rods.