In which type of joint, plates to be fastened are placed one over the other, and riveted by one or more rows of rivets?

In which type of joint, plates to be fastened are placed one over the

1.	In which type of joint, plates to be fastened are placed one over the other, and riveted by one or more rows of rivets?
A.	Chain joint
B.	Butt joint
C.	Zig – Zag joint
D.	Lap joint
Answer» E.

Discussion

No Comment Found

Related MCQs

A single angle of thickness 10 mm is connected to a gusset by 6 numbers of 18 mm diameter bolts, with pitch of 50 mm and with edge distance of 30 mm. The net area in block shear along the line of the transmitted force is
As per IS: 800-1984 specification, how to calculate the gross diameter of a bolt? (If diameter of the bolt is less than or equal to 25 mm.)
A factored eccentric force of 240kN is acting on a bracket connection subjected to a moment parallel to the plane of joint. Assuming the number of bolts as 8.The shear force to be considered on each of the bolt is:
In arc welding process, the arc is shielded in order to:
As per IS 800 for a nominal diameter of 12 mm bolt, the diameter of the hole provided should be:
A circular shaft of diameter 120 mm is welded to a rigid plate by a fillet weld of size 6 mm. If a torque of 8 kNm is applied to the shaft, what is the maximum stress in the weld (to the nearest unit)?
Match List – l (Type of stress) with List – ll (Allowable value of stress) and select the correct answer using the codes given below the lists:(fy = minimum yield stress of steel) List – I List – IIA.Axial tension1.0.75 fyB.Bending tension2.0.66 fyC.Maximum shear stress3.0.60 fyD.Bearing stress4.0.45 fy
High Strength Friction Grip Bolts can be used for(i) Slip resistant connection(ii) Bearing type connection(iii) Shear connection
According to IS 800-2007, the nominal shear capacity of M20 bolt of grade 4.6 with one shear plane passing through bolt shank and one shear plane passing through threaded portion is
Diamond pattern of bolting is beneficial over chain and staggered bolting because

In which type of joint, plates to be fastened are placed one over the other, and riveted by one or more rows of rivets?

Discussion

No Comment Found

Related MCQs

Reply to Comment