In which of the following milling method cutters rotate in direction o – McqOptions

MCQOPTIONS

1.	In which of the following milling method cutters rotate in direction opposite to that in which work is fed?
A.	Up milling
B.	Climb milling
C.	Down milling
D.	None of the mentioned
Answer» B. Climb milling

Discussion

No Comment Found

Related MCQs

Which of the following milling operation will require lower force of cut?
In which of the following methods of milling there would be less radial pressure on the arbor?
In which of the following milling method chip thickness is nearly zero at the end of cut?
In which of the following milling method chip thickness decrease gradually?
IN_WHICH_OF_THE_FOLLOWING_METHODS_OF_MILLING_THERE_WOULD_BE_LESS_RADIAL_PRESSURE_ON_THE_ARBOR??$
Which_of_the_following_milling_operation_will_require_lower_force_of_cut?$
In which of the following methods work piece will have a tendency to be pulled up?
Which of the following will result in best surface finish of job?
In which of the following milling method chip thickness is maximum at the end of cut?
In which of the following milling method chip thickness is nearly zero at the start of cut?