In order to sustain oscillations in a feedback oscillator, the gain sh – McqOptions

MCQOPTIONS

1.	In order to sustain oscillations in a feedback oscillator, the gain should be _________ so the Acl _______.
A.	reduced, equals one
B.	reduced, is less than one
C.	increased, is more than one
D.	increased, is much greater than one
Answer» B. reduced, is less than one

Discussion

No Comment Found

Related MCQs

A two-pole active filter produces a roll-off rate of –20 dB/decade.
For a Wien-bridge oscillator to produce a sustained sine-wave output, the phase shift around the positive feedback loop must be greater than 0°.
The R/2R ladder is commonly used for D/A converters.
The output of an op-amp comparator will be zero when the input voltage exceeds the reference voltage.
An op-amp can be used as a comparator to determine when an input voltage exceeds a certain level.
An op-amp integrator uses a capacitor as the feedback element.
The difference between the UTP and the LTP is the hysteresis voltage.
The output voltage of a summing amplifier is proportional to the sum of the input voltages.
In an op-amp comparator, when the input voltage exceeds a reference voltage, the voltage output changes state.
A positive feedback network for hysteresis improves an op-amp comparator's noise immunity.