In a truss girder of a bridge, a diagonal consists of mild steel flat – McqOptions

MCQOPTIONS

1.	In a truss girder of a bridge, a diagonal consists of mild steel flat 400 ISF (t = 8 mm) and carries a pull of 800 kN. If the gross diameter of the rivets is 26 mm, then the number of rivets required in the splice is ______.
A.	6
B.	7
C.	8
D.	9
Answer» E.

Discussion

No Comment Found

Related MCQs

Which is one of the most efficient types of timber roof trusses?
Figure below is a section of a roof, identify the type _________
The structure shown below as a whole represents _____________
Figure shown below represents __________
In timber roof figure shown below, the part represented by number 2 denotes ____________
In timber roof figure shown below, the part represented by number 1 denotes _________
In timber roof figure shown below, the part represented by number 3 denotes __________
In which of the following truss members the stress depends upon whether the load is moving on top chord or bottom chord?
If the wind pressure at a location is 1000 N/m2, wind directionality factor 0.9 area average factor 0.8, combination factor 1, the design wind pressure is
Double-pitched roof trusses of span 20 m and rise 2.5 m are placed at 8 m spacing. The maximum live load reaction at the supports is nearly