In a long cylindrical rod of radius R and a surface heat flux of q0, what is the uniform internal heat generation rate?

In a long cylindrical rod of radius R and a surface heat flux of q0, w

1.	In a long cylindrical rod of radius R and a surface heat flux of q₀, what is the uniform internal heat generation rate?
A.	2q<sub>0</sub>/R
B.	2q<sub>0</sub>
C.	q<sub>0</sub>/R
D.	2q<sub>0</sub>/3R
Answer» B. 2q<sub>0</sub>

Discussion

No Comment Found

Related MCQs

As the temperature increases, the thermal conductivity of a gas ____________
A plane slab of 100mm thickness generates heat. It is observed that the temperature drop between the center and its surface to be 50 C. If the thickness is increased to 200mm the temperature difference will be ___________
In a long cylindrical rod of radius R and a surface heat flux of q0, what is the uniform internal heat generation rate?
An insulating material with a thermal conductivity k = 0.12W/mK is used for a pipe carrying steam. The local coefficient of heat transfer to the surrounding h = 4 W/m2K. In order to provide effective insulation, what should be the minimum outer diameter of the pipe?
A plane wall is 20cm thick with an area perpendicular to heat flow of 1m2 and has a thermal conductivity of 0.5W/mK. A temperature difference of 100 C is imposed across it. What is the ratio of heat flow?
A steam pipe is covered with two layers of insulating materials, with the better insulating material forming the outer. What is the effect on heat conducted if the two layers are interchanged?
The outer surface of a long cylinder is maintained at constant temperature. The cylinder does not have any heat source. The temperatures in the cylinder will _________
A copper block and an air mass block having similar dimensions are subjected to symmetrical heat transfer from one face of the each block. The other face of the block will be reaching to the same temperature at a rate?
Which of the following expresses the thermal diffusivity of a substance in terms of thermal conductivity of a substance (k), mass density ( ) and specific heat (c)?
For conduction through a spherical wall with constant thermal conductivity and with inner side temperature greater than outer wall temperature in 1-D heat transfer, what is the type of temperature distribution?

In a long cylindrical rod of radius R and a surface heat flux of q0, what is the uniform internal heat generation rate?

Discussion

No Comment Found

Related MCQs

Reply to Comment

In a long cylindrical rod of radius R and a surface heat flux of q₀, what is the uniform internal heat generation rate?