If x(n) is a stable sequence so that X(z) converges on to a unit circl – McqOptions

MCQOPTIONS

1.	If x(n) is a stable sequence so that X(z) converges on to a unit circle, then the complex cepstrum signal is defined as ____________
A.	X(ln X(z))
B.	ln X(z)
C.	X<sup>-1</sup>(ln X(z))
D.	None of the mentioned
Answer» D. None of the mentioned

Discussion

No Comment Found

Related MCQs

Which of the following electromagnetic signals has a frequency range of 30kHz-3MHz?
If F<sub>1</sub> and F<sub>2</sub> are the lower and upper cutoff frequencies of a band pass signal, then what is the condition to be satisfied to call such a band pass signal as narrow band signal?
The term bandwidth represents the quantitative measure of a signal.
If a power signal has its power density spectrum concentrated about zero frequency, the signal is known as ______________
What is the Fourier transform of the signal x(n)=u(n)?
If c<sub>x</sub>(n) is the complex cepstrum sequence obtained from the inverse Fourier transform of ln X( ), then what is the expression for c<sub> </sub>(n)?
If x(n) is a stable sequence so that X(z) converges on to a unit circle, then the complex cepstrum signal is defined as ____________
The sequence x(n)= ( frac{sin _c n}{ n} ) does not have both z-transform and Fourier transform.
What is the Fourier transform of the signal x(n) which is defined as shown in the graph below?
What is the energy density spectrum Sxx( ) of the signal x(n)=a<sup>n</sup>u(n), |a|<1?