If the axial length of a drainage basin is 35 km and its form factor i – McqOptions

MCQOPTIONS

1.	If the axial length of a drainage basin is 35 km and its form factor is 0.2, the total area of the basin is
A.	205 sq. km.
B.	215 sq. km.
C.	225 sq. km.
D.	235 sq. km.
Answer» E.

Discussion

No Comment Found

Related MCQs

With the usual meanings ofletters, the equation is used for determining the velocity of ground water flow in metres per day. It is known as
In the derivation of Thiem's formula , the following assumption is not applicable
If the area of storm hydrograph is equal to 10 cm, the ordinates of a unit hydrograph may be obtained by dividing the ordinates of the storm hydrograph by
For calculating the evaporation rate over a reservoir surface = 0.771 (1.465 - 0.00732 ) (0.44 - 0.007375 ) ( - ), the equation is given by
Burge formula cumecs is based upon
The respective storm totals at three surrounding stations , and are 110, 90 and 70 mm. If the normal annual precipitation amounts at stations , , and are respectively 1000, 1100, 1200 and 1250 mm, the estimated storm precipitation at is
The area enclosed by the adjacent isohyets of a catchment basin are shown under : The average depth of annual precipitation in the catchment basin will be
The elevation of the watershed is : (where letters carry their usual meanings)
If the slope of a line for infiltration capacity curve is , the value of constant in Horton's equation of infiltration capacity curve, is
The equation - = φ for determining the infiltration capacity, was suggested by