Geometric design of holding apron of these statements$? – McqOptions

MCQOPTIONS

1.	Geometric design of holding apron of these statements$?
A.	1 and 2 are correct
B.	2 and 3 are correct
C.	1 and 3 are correct
D.	1 alone is correct
Answer» E.

Discussion

No Comment Found

Related MCQs

The landing and takeoff of the air craft is made against the direction of wind. In no case the centre line of the runway should make an angle with the wind direction exceeding%!
International Civil Aviation Organization (I.C.A.O.) was set up at Montreal (Canada), in%!
Runway threshold is indicated by a series of parallel lines starting from a distance of%!
The cruising speed of the aircraft is 500 kmph. If there is a head wind of 50 kmph, then the air speed and ground speed of the aircraft respectively will be%!
In Instrumental landing system, the middle markers are located%!
The length of runway is increased per 300 m rise above M.S.L.%!
<p>The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60¬¨&sbquo;àû, the distance of centre of rotation from the nearer main gear, is%!</p>
The distance between main gears is 10 m, and the distance of nose gear from centre of main gears is 30 m. If the angle of turning is 60¬¨‚àû, the distance of centre of rotation from the nearer main gear, is%!
For supersonic transport aircraft, the minimum turning radius of taxiway is%!
For Class ‚Äö√Ñ√≤A‚Äö√Ñ√¥ Air port the difference of reduced levels of higher and lower edges of the conical surface, is%!