Geometric design of holding apron of these statements – McqOptions

MCQOPTIONS

1.	Geometric design of holding apron of these statements
A.	and 2 are correct
B.	and 3 are correct
C.	and 3 are correct
D.	alone is correct
Answer» E.

Discussion

No Comment Found

Related MCQs

The reduced levels of the ends and of a runway are 3025 m and 3035 m and that of its mid-point is 3015 m. The reduced level of the horizontal surface, is
For Class Air port the difference of reduced levels of higher and lower edges of the conical surface, is
Zero fuel weight of an aircraft is_________________?
Which of the following is used for servicing and repairs of the aircraft ?
Which of the following is an example of failure in flexible pavements ?
Which of the following factors are taken into account for estimating the runway length required for aircraft landing ?_x005F_x000D_1. Normal maximum temperature_x005F_x000D_2. Airport elevation_x005F_x000D_3. Maximum landing weight_x005F_x000D_4. Effective runway gradient_x005F_x000D_Select the correct answer using the codes given below Codes?
The width and interval of transverse centre line bars along the extended centre line of runway, in approach lighting system are_________________?
The total length of a runway is 1000 m. The elevation at distance 0,200 m, 400 m, 600 m, 800 m and 1000 m are 100.0 m, 99.2 m, 101.0 m, 101.8 m, 101.4 m and 101.0 m respectively. The effective gradient of runway will be______________?
The slope of the transitional surface for A, B and C type of runway shall be_______________?
The slope of the obstruction clearance line from the boundary of the heliport should be________________?