For the BJT to operate in the saturation region, the base-emitter junc – McqOptions

MCQOPTIONS

1.	For the BJT to operate in the saturation region, the base-emitter junction must be ________-biased and the base-collector junction must be ________-biased.
A.	forward, forward
B.	forward, reverse
C.	reverse, reverse
D.	reverse, forward
Answer» B. forward, reverse

Discussion

No Comment Found

Related MCQs

In an emitter-bias configuration, the ________ the resistance RE, the ________ the stability factor, and the ________ stable is the system.
The ________the stability factor, the ________sensitive the network is to variations in that parameter.
A significant increase in leakage current due to increase in temperature creates ________between IB curves.
As the temperature increases, ________, VBE ________, and ICO ________ in value for every 10ºC.
In any amplifier employing a transistor, the collector current IC is sensitive to ________.
________ is less dependent on the transistor beta.
In a transistor-switching network, the operating point switches from ________ to ________ regions along the load line.
In a transistor-switching network, the level of the resistance between the collector and emitter is ________ at the saturation and is ________at the cutoff.
________is the least stabilized circuit.
In a collector feedback bias circuit, the current through the collector resistor is ________ and the collector current is ________.