For obtaining maximum current when we conduct the Slip Test on a syn – McqOptions

MCQOPTIONS

1.	For obtaining maximum current when we conduct the Slip Test on a synchronous machine, its armature field will align along __________
A.	d-axis
B.	q-axis
C.	45 to d-axis
D.	45 to q-axis
Answer» C. 45 to d-axis

Discussion

No Comment Found

Related MCQs

For obtaining maximum current when we conduct the Slip Test on a synchronous machine, its armature field will align along __________
for a synchronous motor, its power factor __________
While finding the parameters for an alternator, its voltage regulation is found to be negative. Then the load connected to it must be __________
For a 400 V, 3 phase alternator gives an open circuit voltage of 380V and armature current of 38A at a field current of 20A. Then the synchronous reactance of the machine is?
Mark the correct expression for alternator working at a lagging power factor.
A salient pole synchronous generator has following per-unit parameter Xd = 1.2 pu, Xq = 0.8pu, ra = 0.25 ohms. Then the armature current at 0.8 lagging is?
If the internal pf angle of a synchronous motor is 30 degree. Then the quadrature axis component of the armature is?
If the internal power factor angle of synchronous motor is 30 degree. Then the direct-axis component of the armature current will be __________
In salient-pole machines, the armature mmf cannot be accounted for by introducing one equivalent reactance due to __________