For a load impedance of ZL=60-j80. Design of 2 single-stub shunt tuning networks to match this load to a 50Ω line is to be done. What is the normalized admittance obtained so as to plot it on smith chart?

For a load impedance of ZL=60-j80. Design of 2 single-stub shunt tuni

1.	For a load impedance of ZL=60-j80. Design of 2 single-stub shunt tuning networks to match this load to a 50Ω line is to be done. What is the normalized admittance obtained so as to plot it on smith chart?
A.	1+j
B.	0.3+j0.4
C.	0.4+j0.3
D.	0.3-j0.4
Answer» C. 0.4+j0.3

Discussion

No Comment Found

Related MCQs

In series stub matching, if the normalized impedance at a point on the transmission line to be matched is 1+j1.33. Then the reactance of the series stub used for matching is:
After impedance matching, if a graph is plot with frequency v/s reflection co-efficient of the transmission line is done, then at the frequency point for which the design is done, which of the following is true?
If the normalized admittance at a point on a transmission line to be matched is 1+j1.47. Then the normalized susceptance of the stub used for shunt stub matching is:
For a load impedance of ZL=60-j80. Design of 2 single-stub shunt tuning networks to match this load to a 50Ω line is to be done. What is the normalized admittance obtained so as to plot it on smith chart?
The two adjustable parameters in single stub matching are distance‘d’ from the load to the stub position, and _________
AFTER_IMPEDANCE_MATCHING,_IF_A_GRAPH_IS_PLOT_WITH_FREQUENCY_V/S_REFLECTION_CO-EFFICIENT_OF_THE_TRANSMISSION_LINE_IS_DONE,_THEN_AT_THE_FREQUENCY_POINT_FOR_WHICH_THE_DESIGN_IS_DONE,_WHICH_OF_THE_FOLLOWING_IS_TRUE??$
In_series_stub_matching,_if_the_normalized_impedance_at_a_point_on_the_transmission_line_to_be_matched_is_1+j1.33._Then_the_reactance_of_the_series_stub_used_for_matching_is:$
If the normalized admittance at a point on a transmission line to be matched is 1+j1.47. Then the normalized susceptance of the stub used for shunt stub matching is?
For a load impedance of ZL=60-j80. Design of 2 single-stub shunt tuning networks to match this load to a 50‚âà√≠¬¨¬© line is to be done. What is the normalized admittance obtained so as to plot it on smith chart?$
For co-axial lines and waveguides, ________ is more preferred.

For a load impedance of ZL=60-j80. Design of 2 single-stub shunt tuning networks to match this load to a 50Ω line is to be done. What is the normalized admittance obtained so as to plot it on smith chart?

Discussion

No Comment Found

Related MCQs

Reply to Comment