Determine operating current of the relay, for 5 A, 2.2-sec IDMT rating – McqOptions

MCQOPTIONS

1.	Determine operating current of the relay, for 5 A, 2.2-sec IDMT rating, and 125% relay setting?
A.	11 A
B.	4 A
C.	12.5 A
D.	6.25 A
Answer» E.

Discussion

No Comment Found

Related MCQs

A blocked electric current of 4000 A is passing through the primary side of a converter having 400/5 A current. The plug setting of the electric current relay is set at 50% at the secondary of the electric current converter. What will be the plug setting multiplier?
For differential protection of power transformer (delta-delta) the current transformers will have
Impedance relay is used on______ transmission lines.
A 11 kV 100 MVA alternator is grounded through a resistance of 4 Ω. The C.T.s have a ratio of 500/5. The relay is set to operate when there is an out of balance current of 2 A. What percentage of generator winding will be protected by the percentage differential protection scheme?
If for an IDMT relay with a plug setting of 50% and a CT ration of 400/5, the current is 3000 A, then the plug setting multiplier would be:
In case of short-tie-line fed at both the ends, for protection
Buchholz relay is used on:
A 3 – Phase transformer rated for 33 kV/ 11kV is connected in delta/star as shown in figure. The current transformers (CTs) on low land high voltage sides have a ratio of 500/5. Find the current \({i_1}\) and \({i_2}\), of the fault current is 300 A as shown in figure
Distance protection relay is used in:
Determine operating current of the relay, for 5 A, 2.2-sec IDMT rating, and 125% relay setting?