Based on drained triaxial shear tests on sands and clays, the representative variations of volumetric strain (ΔV/V) with the shear strain (γ) is shown in the figure.Choose the CORRECT option regarding the representative behaviour exhibited by Curve P and Curve Q.

Curve P represents dense sand and normally consolidated clay, while Curve Q represents loose sand and overconsolidated clay

Curve P represents loose sand and normally consolidated clay, while urve Q represents dense sand and overconsolidated clay

Curve P represents dense sand and overconsolidated clay, while Curve Q represents loose sand and normally consolidated clay

Curve P represents loos sand and oveconsolidated clay, while Curve Q represents dense sand and normally consolidated clay

Based on drained triaxial shear tests on sands and clays, the represen

1.	Based on drained triaxial shear tests on sands and clays, the representative variations of volumetric strain (ΔV/V) with the shear strain (γ) is shown in the figure.Choose the CORRECT option regarding the representative behaviour exhibited by Curve P and Curve Q.
A.	Curve P represents loose sand and normally consolidated clay, while urve Q represents dense sand and overconsolidated clay
B.	Curve P represents dense sand and overconsolidated clay, while Curve Q represents loose sand and normally consolidated clay
C.	Curve P represents dense sand and normally consolidated clay, while Curve Q represents loose sand and overconsolidated clay
D.	Curve P represents loos sand and oveconsolidated clay, while Curve Q represents dense sand and normally consolidated clay
Answer» C. Curve P represents dense sand and normally consolidated clay, while Curve Q represents loose sand and overconsolidated clay

Discussion

No Comment Found

Related MCQs

Clay layer A with single drainage and coefficient of consolidation Cv takes 6 months to achieve 50% consolidation. The time to layer B of the same thickness with double drainage and coefficient of consolidation \(\frac{{Cv}}{2}\) to achieve the same degree of consolidation.
Oedometer is used to calculate which of the following soil parameter
A clay layer of thickenss H has a preconsolidation pressure pc and an initial void ratio e0. The initial effective overburden stress at the mid-height of the layer is p0. At the same location, the increment in effective stress due to applied extrenal load is Δp. The comprssion and swelling indices of the clay are Cc and Cs, respectively. If P0 < Pc <(P0 + Δp), then the the correct expression to estimate the consolidation settlement (Sc) of the clay layers is
Consider the following statements:1. Secondary consolidation of soil follows Terzaghi’s one-dimensional theory of consolidation.2. Consolidation is a function of total stress.3. Even after complete dissipation of excess pore pressure, the soil undergoes a little more consolidation.Which of the above statements is/are correct?
In a consolidation test, when the load is changed from 50 kN/m2 to 100 kN/m2, then the void ratio changes from 0.80 to 0.60. The coefficient of compressibility will be:
For a particular loading Condition unsaturated clay layer undergoes 30% consolidation in a period of 180 days. What would be the additional time required for further 20% consolidation to occur
In a tri-axial test carried out on cohesion less soil sample with a cell pressure of 20 kPa, the observed value of applied stress at the point of failure was 40 kPa. The angle of internal friction of the soil is _________.
If the co-efficient of permeability is doubled and the co-efficient of volume compressibility is simultaneously haved, the co-efficient of consolidation
In a saturated clay layer consolidation with single drainage, the initial isochrones is a
For finding out the time ‘t1’ required to achieve 50% consolidation of 1 m thick clayey strata resting on an impermeable rock at the bottom and sandy soil at top, a laboratory consolidation test was carried out, using 1 cm thick sample obtained from the same strata. Time “t12” was taken by it to achieve 25% consolidation, under double drainage conditions in the laboratory.Choose the correct value of the ratio \(\frac{t_1}{t_2}\) from the following:

Based on drained triaxial shear tests on sands and clays, the representative variations of volumetric strain (ΔV/V) with the shear strain (γ) is shown in the figure.Choose the CORRECT option regarding the representative behaviour exhibited by Curve P and Curve Q.

Discussion

No Comment Found

Related MCQs

Reply to Comment