As per the stress block defined in IS 456-2000, the limiting depth of neutral axis in a flexural member having effective depth ‘d’ reinforced with Fe 550 grade steel in tension side is

As per the stress block defined in IS 456-2000, the limiting depth of

1.	As per the stress block defined in IS 456-2000, the limiting depth of neutral axis in a flexural member having effective depth ‘d’ reinforced with Fe 550 grade steel in tension side is
A.	0·48 d
B.	0·53 d
C.	0·42 d
D.	0·44 d
Answer» E.

Discussion

No Comment Found

Related MCQs

In a simply supported 9 m long beam, the effective depth should be a minimum of (approximately) d mm is required for assuming the vertical deflection to be satisfactory
For a two-way simply supported slab of shorter span (upto 3.5 m) with mild steel reinforcement. the span to overall depth is generally taken as:
A singly reinforced rectangular concrete beam has a width of 150 mm and an effective depth of 330 mm. The characteristic compressive strength of concrete is 20 MPa and the tensile strength of steel is 415 MPa. Adopt the stress block for concrete as per IS 456-2000 and take the limiting value of depth of neutral axis as 0.48 times the effective depth of the beam for considering as a balanced section. What is the likely approximation for the limiting value of the moment of resistance of the beam?
Lifting of the corners of slab is prevented by providing_______ reinforcement.
In beams the maximum area of the reinforcement in tension reinforcement shall not exceed
According to IS 456, two-way slabs with corners held down are assumed to be divided in each direction into middle strips and edge strips such that the width of the middle strip is?
If d is the effective depth, b is the width and D is the overall depth, then the maximum area of compression reinforcement in a beam is given by
A beam of size 250 mm width and 460 mm effective depth is subjected to limit state moment of 146 kNm. If M 20 grade concrete and Fe 415 steel are used, the area of steel required will be
Diagonal tension in beam _____
A simply supported beam having 200 mm width and 450 mm effective depth supports a total uniformly distributed load of 2,00,000 N. The nominal shear stress will be nearly

As per the stress block defined in IS 456-2000, the limiting depth of neutral axis in a flexural member having effective depth ‘d’ reinforced with Fe 550 grade steel in tension side is

Discussion

No Comment Found

Related MCQs

Reply to Comment