As a general rule, the lower the value of the speedâ€“power produ – McqOptions

MCQOPTIONS

1.	As a general rule, the lower the value of the speedâ€“power product, the better the device because of its:
A.	long propagation delay and high power consumption
B.	long propagation delay and low power consumption
C.	-
D.	-
Answer» C. -

Discussion

No Comment Found

Related MCQs

The problem of the V OH(min) of a TTL IC being too low to drive a CMOS circuit and meet the CMOS requirement of V IH(min) is usually easily overcome by:
How is the speedâ€“power product of a logic family determined?
Why are the maximum value of V OL and the minimum value of V OH used to determine the noise margin rather than the typical values for these parameters?
From the following specifications determine the fan-out for the logic family.
The problem of interfacing IC logic families that have different supply voltages ( V CC 's) can be solved by using a:
The rise time ( t r ) is the time it takes for a pulse to rise from its ________ point up to its ________ point. The fall time ( t f ) is the length of time it takes to fall from the ________ to the ________ point.
As a general rule, the lower the value of the speedâ€“power product, the better the device because of its:
Assume that a particular IC has a supply voltage ( V cc ) equal to +5 V and I CCH = 10 mA and I CCL = 23 mA. What is the power dissipation for the chip?