________ analog-to-digital converters (ADCs) use no clock signal, beca – McqOptions

MCQOPTIONS

1.	________ analog-to-digital converters (ADCs) use no clock signal, because there is no timing or sequencing required.
A.	Actuator
B.	Dual
C.	Flash
D.	Bipolar
Answer» D. Bipolar

Discussion

No Comment Found

Related MCQs

A binary-weighted digital-to-analog converter has a feedback resistor, R, of 12 k. If 50 A of current is through the resistor, the voltage out of the circuit is:
The resolution of a 0–5 V 6-bit digital-to-analog converter (DAC) is:
An 8-bit digital-to-analog converter (DAC) has a resolution of 0.125 V.
A binary-weighted resistor used in a digital-to-analog converter (DAC) is only practical up to a resolution of ________.
The key advantage of the successive approximation analog-to-digital converter (ADC) is its conversion speed.
One way to determine the resolution of a digital-to-analog converter (DAC) is to compare the ratio of one step voltage to the maximum output voltage.
Inaccurate analog-to-digital conversion may be due to ____________.
In a binary-weighted digital-to-analog converter (DAC), the values of the input resistors are chosen to be proportional to the binary weights of the corresponding input bits.
Which is not an analog-to-digital (ADC) conversion error?
A binary-weighted digital-to-analog converter has a feedback resistor, Rf, of 12 k. If 50 A of current is through the resistor, the voltage out of the circuit is: