An epicyclic gear train has 3 shafts A,B and C. A is an input shaft running at 100 r.p.m. clockwise. B is an output shaft running at 250 r.p.m. clockwise. Torque on a is 50 kNm. C is a fixed shaft. The torque to fix C

cannot be determined as the data is insufficient

An epicyclic gear train has 3 shafts A,B and C. A is an input shaft r

1.	An epicyclic gear train has 3 shafts A,B and C. A is an input shaft running at 100 r.p.m. clockwise. B is an output shaft running at 250 r.p.m. clockwise. Torque on a is 50 kNm. C is a fixed shaft. The torque to fix C
A.	is 20 kNm anticlockwise
B.	is 30 kNm anticlockwise
C.	is 30 kNm clockwise
D.	cannot be determined as the data is insufficient
Answer» B. is 30 kNm anticlockwise

Discussion

No Comment Found

Related MCQs

An epicyclic gear train has 3 shafts A,B and C. A is an input shaft running at 100 r.p.m. clockwise. B is an output shaft running at 250 r.p.m. clockwise. Torque on a is 50 kNm. C is a fixed shaft. The torque to fix C
In a simple gear train, if the number of idler gears is odd, then the direction of motion of driven gear will
Consider the following statements:When two gears are meshing, the clearance is given by the1. difference between dedendum of one gear and addendum of the mating gear.2. difference between total and the working depth of a gear tooth.3. distance between the bottom land of one gear and the top land of the mating gear.4. difference between the radii of the base circle and the dedendum circle. Which of these statements are correct?
Match list I with list II List I List IIA. Compound train 1. Hart mechanismB. Quick return mechanism 2. Coriolis forceC. Exact straight line motion 3. Transmission of motion around bends and cornersD. Approximate straight line motion 4. Watt mechanism
Which of the following statements are correct for mating gears with involute profiles?(i) The pressure angle, from the start of the engagement to the end of the engagement, remains constant.(ii) The pressure angle is maximum at the beginning of the engagement, reduces to zero at pitch point, starts decreasing and again becomes maximum at the end of the engagement.(iii) The face and flank of the teeth are generated by a single curve and the normal to this curve at any point is tangent to the base circle of the gear.(iv) The centre distance for a pair of mating gears can be varied within limits without altering the velocity ratio.Select the correct answer using the code given below.
Two involute gears are designed to mesh for a given centre distance and a given angular velocity ratio (other than 1). During assembly, the centre distance has increased slightly. Then which of the following changes occur?(i) Velocity ratio changes(ii) Pressure angle changes(iii) Pitch circle diameter changes(iv) Working depth changes(v) Base circle radius changesSelect the correct answer using the code given below.
Pressure angle of involute gears does not exceed 250, since
The velocity ratio in the case of the compound train of wheels is equal to
Which of the following statements are correct for mating gears with involute profiles?
Two involute gears are designed to mesh for a given centre distance and a given angular velocity ratio (other than 1). During assembly, the centre distance has increased slightly. Then which of the following changes occur?

An epicyclic gear train has 3 shafts A,B and C. A is an input shaft running at 100 r.p.m. clockwise. B is an output shaft running at 250 r.p.m. clockwise. Torque on a is 50 kNm. C is a fixed shaft. The torque to fix C

Discussion

No Comment Found

Related MCQs

Reply to Comment