A thermistor is used for ____________ – McqOptions

MCQOPTIONS

1.	A thermistor is used for ____________
A.	Over voltage protection
B.	Temperature alarm circuit
C.	Automatic light control
D.	Automatic sensor
Answer» C. Automatic light control

Discussion

No Comment Found

Related MCQs

Current I = 1 + ( sqrt{2} ) (sin ( t + 60 )) A is passed through three meters. The respective readings will be?
Given a system function H(s) = ( frac{1}{s+10} ). Let us consider a signal sin 10t. Then the steady state response is ___________
A Low-pass filter circuit has a cut-off frequency of 50 kHz. The bandwidth of the filter is ______________
For providing a Roll-off greater than 60dB/decade/pole, filters with which characteristics are useful?
For a Band Pass Filter, the slope of the filter is given as 80dB/decade. The order of the Band Pass Filter is __________
The filter which passes all frequencies above fc by attenuating significantly, all frequencies above fc is _______________
A particular band-pass function has a network function as H(s) = ( frac{s}{s^2+2s+1} ) then, its quality factor Q is ___________
Two network functions are given below.H1 = ( frac{1}{s^2 + 2s + 1} ), H2 = ( frac{1}{s^3+3s^2+3s+1} )
A thermistor is used for ____________
In a parallel RL circuit, 10 A current enters into the resistor R and 15 A current enters into the Inductor L. The total current I is _____________