A soil sample has a void ratio of 0.5; its porosity will be

1.	A soil sample has a void ratio of 0.5; its porosity will be
A.	50%
B.	66%
C.	100%
D.	33%
Answer» E.

Discussion

No Comment Found

Related MCQs

A soil sample is having a specific gravity of 2.60 and void ratio 0.78, the moisture content in % required to fully saturate the soil at that void ratio would be
If e represents the void ratio of the soil and G is its specific gravity, the critical gradient is:
A saturated sand sample has a dry unit weight of 18 kN/m3 and a specific gravity of 2.65. If γw = 9.81 kN/m3, then, what is the water content of the soil?
A project engineer receives a laboratory report of a sample of soil having a moist unit weight of soil is 20.5 KN/m3, water content available is 25 % and the specific gravity of the solid of the soil is 3.35. Find the dry unit weight of the soil.
A soil sample has a porosity of 40% and the specific gravity of solid is 2.70. If the soil is 50% saturated, the unit weight will be nearly
For a given soil mass with water content of 15 % the void ratio is 0.55 and specific gravity of soil particles is 2.6. The degree of saturation of soil is
Consider the following effects as indicative of complete saturation of a soil sample:1. Pore water pressure is positive.2. Volume of water to volume of voids is equal to 1.3. Relative density is equal to 1.Which of the above statements are correct?
A soil sample taken from the field has specific gravity of 2.5 and void ratio of 0.75. The water content required to fully saturate the soil at that void ratio is:
Consider the following statements:1. Knowledge about moisture content is necessary to determine permeability.2. Some typical marine clay may have moisture content as high as 400%.3. Sand bath method of moisture content determination is not suitable for soils containing organic matter.Which of the above statements an correct?
A unit phase diagram is normally divided into three parts. What does the top, middle and bottom part represent?

A soil sample has a void ratio of 0.5; its porosity will be

Discussion

No Comment Found

Related MCQs

Reply to Comment