A resistor of 10 k with a tolerance of 5% is connected in parallel wi – McqOptions

MCQOPTIONS

1.	A resistor of 10 k with a tolerance of 5% is connected in parallel with 5 k resistors of 10% tolerance. The tolerance limit is __________
A.	9%
B.	12.4%
C.	8.33%
D.	7.87%
Answer» D. 7.87%

Discussion

No Comment Found

Related MCQs

In Maxwell s capacitance bridge for calculating unknown inductance, the various values at balance are, R1 = 300 , R2 = 700 , R3 = 1500 , C4 = 0.8 F. The values of R1, L1 and Q factor, if the frequency is 1100 Hz are ____________
In the Two wattmeter method of measuring power in a balanced three-phase circuit, one wattmeter shows zero and the other positive maximum. The load power factor is ___________
A resistor of 10 k with a tolerance of 5% is connected in parallel with 5 k resistors of 10% tolerance. The tolerance limit is __________
The voltage drop across a standard resistor of 0.2 is balanced at 83 cm. The magnitude of the current, if the standard cell emf of 1.53 V is balanced at 42 m is ___________
An RLC series circuit has a resistance R of 20 and a current which lags behind the applied voltage by 45 . If the voltage across the inductor is twice the voltage across the capacitor, the value of inductive resistance is ____________