A nozzle is fitted at the end of a pipe of length 300 m and of diameter 10 cm for transmitting water. What is the diameter of the nozzle considering maximum transmission of power through the nozzle (f = 0.009)

A nozzle is fitted at the end of a pipe of length 300 m and of diamete

1.	A nozzle is fitted at the end of a pipe of length 300 m and of diameter 10 cm for transmitting water. What is the diameter of the nozzle considering maximum transmission of power through the nozzle (f = 0.009)
A.	2.6 cm
B.	2.5 cm
C.	2.4 cm
D.	2.7 cm
Answer» B. 2.5 cm

Discussion

No Comment Found

Related MCQs

If U∞ = free stream velocity, u = velocity at y, and δ = boundary layer thickness, then in a boundary layer flow, the momentum thickness θ is given by
A block of 2 kg slides on a parallel surface at a speed of 4 m/s. It falls on an unpressed spring and presses it until the block is completely motionless. The amount of kinetic friction is 15 N and the spring constant is 10,000 N/m. Spring presses with _____.
For fully developed laminar flow through a circular pipe with Reynolds number Re the friction factor is
A nozzle is fitted at the end of a pipe of length 300 m and of diameter 10 cm for transmitting water. What is the diameter of the nozzle considering maximum transmission of power through the nozzle (f = 0.009)
If x is the distance measured from the leading edge of a flat plate, the laminar boundary layer thickness varies as
For laminar flow over a flat plate, the thickness of the boundary layer at a distance from the leading edge is found to be 5 mm. The thickness of the boundary layer at a downstream section, which is at twice the distance of the previous section from the leading edge, will be
An incompressible fluid flows over a flat plate with zero pressure gradient. The boundary layer thickness is 1 mm at a location where the Reynolds number is 1000. If the velocity of the fluid alone is increased by a factor of 4, then the boundary layer thickness at the same location, in mm will be
A boundary is known as hydrodynamically smooth if:
A fluid is flowing over a flat plate. At a distance of 8 cm from the leading edge, the Reynolds number is found to be 25600. The thickness of the boundary layer at this point is
Flow separation in flow past a solid object is caused by

A nozzle is fitted at the end of a pipe of length 300 m and of diameter 10 cm for transmitting water. What is the diameter of the nozzle considering maximum transmission of power through the nozzle (f = 0.009)

Discussion

No Comment Found

Related MCQs

Reply to Comment