A Hooke’s joint is used to connect two – McqOptions

MCQOPTIONS

1.	A Hooke’s joint is used to connect two
A.	coplanar and non-parallel shafts
B.	non-coplanar and non-parallel shafts
C.	coplanar and parallel shafts
D.	non-coplanar and parallel shafts
Answer» C. coplanar and parallel shafts

Discussion

No Comment Found

Related MCQs

A Hooke’s joint is used to connect two
In automobiles, Hooke’s joint is used between which of the following?
THE_FRICTIONAL_TORQUE_TRANSMITTED_BY_A_DISC_OR_PLATE_CLUTCH_IS_SAME_AS_THAT_OF?$
In automobiles, Hooke‚Äö√Ñ√∂‚àö√ë‚àö¬•s joint is used between which of the following?$#
The_frictional_torque_transmitted_by_a_cone_clutch_is_same_as_that_of$
The angle between the axes of two shafts connected by Hooke‚Äö√Ñ√∂‚àö√ë‚àö¬•s joint is 18¬¨¬®‚Äö√†√ª. Determine the angle turned through by the driving shaft when the velocity ratio is maximum.$
Two shafts with an included angle of 160¬¨¬®‚Äö√†√ª are connected by a Hooke‚Äö√Ñ√∂‚àö√ë‚àö¬•s joint. The driving shaft runs at a uniform speed of 1500 r.p.m. The driven shaft carries a flywheel of mass 12 kg and 100 mm radius of gyration. Find the maximum angular acceleration of the driven shaft.$
A Hooke‚Äö√Ñ√∂‚àö√ë‚àö¬•s joint is used to connect two$
The frictional torque transmitted in a conical pivot bearing, considering uniform wear, i?
The frictional torque transmitted in a flat pivot bearing, considering uniform pressure, is