_A cantilever of length ‚Äö√Ñ√≤L‚Äö√Ñ√¥ is subjected to a bending moment ‚Äö√Ñ√≤M‚Äö√Ñ√¥ at its free end. If EI is the flexural rigidity of the section, the deflection of the free end, is$?

_A cantilever of length ‚Äö√Ñ√≤L‚Äö√Ñ√¥ is subjec

1.	_A cantilever of length ‚Äö√Ñ√≤L‚Äö√Ñ√¥ is subjected to a bending moment ‚Äö√Ñ√≤M‚Äö√Ñ√¥ at its free end. If EI is the flexural rigidity of the section, the deflection of the free end, is$?
A.	ML/EI
B.	ML/2EI
C.	ML¬¨‚â§/2EI
D.	ML¬¨‚â§/3EI
Answer» E.

Discussion

No Comment Found

Related MCQs

In a shaft, the shear stress is not directly proportional to%!
Pick up the incorrect statement from the following: The torsional resistance of a shaft is directly proportional to%!
The general expression for the B.M. of a beam of length l is the beam carries M = (wl/2) x ‚Äö√Ñ√¨ (wx¬¨‚â§/2)%!
The maximum bending moment for a simply supported beam with a uniformly distributed load w/unit length, is%!
*$_Inertia of a rectangular section of width and depth about an axis passing the moment of through C.G. and parallel to its width is?
*$_A simply supported beam carries varying load from zero at one end and w at the other end. If the length of the beam is a, the maximum bending moment will be?
*$_For the close coil helical spring of the maximum deflection is?
*$_A bar L metre long and having its area of cross-section A, is subjected to a gradually applied tensile load W. The strain energy stored in the bar is?
*$_For determining the support reactions at A and B of a three hinged arch, points B and Care joined and produced to intersect the load line at D and a line parallel to the load line through A at D‚Äö√Ñ√¥. Distances AD, DD‚Äö√Ñ√¥ and AD‚Äö√Ñ√¥ when measured were 4 cm, 3 cm and 5 cm respectively. The angle between the reactions at A and B is?
*$_A spring of mean radius 40 mm contains 8 action coils of steel (N = 80000 N/mm¬¨‚â§), 4 mm in diameter. The clearance between the coils being 1 mm when unloaded, the minimum compressive load to remove the clearance, is?

_A cantilever of length ‚Äö√Ñ√≤L‚Äö√Ñ√¥ is subjected to a bending moment ‚Äö√Ñ√≤M‚Äö√Ñ√¥ at its free end. If EI is the flexural rigidity of the section, the deflection of the free end, is$?

Discussion

No Comment Found

Related MCQs

Reply to Comment