A block 100mm x 100mm base and 10mm height. What will the direct shear – McqOptions

MCQOPTIONS

1.	A block 100mm x 100mm base and 10mm height. What will the direct shear stress in the element when a tangential force of 10kN is applied to the upper edge to a displacement 1mm relative to lower face?
A.	1Pa
B.	1MPa
C.	10MPa
D.	100Pa
Answer» C. 10MPa

Discussion

No Comment Found

Related MCQs

The transverse shear stress acting in a beam of rectangular cross-section, subjected to a transverse shear load, is ____________
Which of the following stresses are associated with the tightening of a nut on a bolt?P. Crushing and shear stress in threadsQ. Bending stress due to the bending of boltR. Torsional shear stress due to frictional resistance between the nut and the boltSelect the correct answer using the codes given below:
What is the formula for shear stress?
The stress induced in a body, when subjected to two equal and opposite forces which are acting tangentially across the resisting section resulting the shearing of the body across its section is called ____________
A diagram which shows the variations of the axial load for all sections of the pan of a beam is called ____________
A material has a Poisson’s ratio of 0.5. If uniform pressure of 300GPa is applied to that material, What will be the volumetric strain of it?
Which type of stress does in a reinforcement bar is taken by the concrete?
If a bar of large length when held vertically and subjected to a load at its lower end, its won-weight produces additional stress. The maximum stress will be ____________
In a body loaded under plane stress conditions, what is the number of independent stress components?
The stress which acts in a direction perpendicular to the area is called ____________