A 10 bit A/D converter is used to digitise an analog signal in the 0 t – McqOptions

MCQOPTIONS

1.	A 10 bit A/D converter is used to digitise an analog signal in the 0 to 5 V range. The maximum peak to peak ripple voltage that can be allowed in the d.c. supply voltage is
A.	nearly 100 mV
B.	nearly 50 mV
C.	nearly 25 mV
D.	nearly 5.0 mV
Answer» E.

Discussion

No Comment Found

Related MCQs

The state transition given below is realized by a clocked JK FF. StateTransitionQnQn+100011011The JK input to realize the transition is
The octal equivalent of the HEX number AB.CD is
A mod-2 counter followed by a mod-5 counter is
The output Qn of a J-K flip-flop is zero. It change to 1 when a clock pulse is applied. The input Jn and Kn are respectively
A 5 bit D/A converter has a current output for a digital input of 10100. If an output current of 10 m A is produced, what will Iout be for a digital input of 11101?
For a MOD-12 counter, FF hasa tpd = 60 ns. NAND gate has a tpd of 25 ns. The clock frequency is
Assuming that only X and Y logic inputs are available and their complements X and Y are not available, then what is the minimum number of two-input nand gates require to implement X Y?
The minimum number of NAND gates required to implement A + AB + ABC is equal to
An 8-bi t di gi t al -r amp ADC wi t h a 40 mV resolution uses a clock frequency of 2.5 MHz and a comparator with VT = 1mV. The digital output for VA = 6.000 V is
The increasing order of speed of data access for the following devices is (i) Cache Memory(ii) CDROM (iii) Dynamic RAM (iv) Processor Registers (v) Magnetic Tape Codes: