Explore topic-wise MCQs in Testing Subject.

This section includes 657 Mcqs, each offering curated multiple-choice questions to sharpen your Testing Subject knowledge and support exam preparation. Choose a topic below to get started.

1.

The protocol that is used in the signaling network is called

A. signal transport ports
B. signaling network
C. Signaling System Seven
D. service control point
Answer» D. service control point
2.

Find the bandwidth for the AM if we need to modulate a 5-KHz voice

A. 10 KHz
B. 20 KHz
C. 30 KHz
D. 40 KHz
Answer» B. 20 KHz
3.

The theoretical downstream data rate is

A. 10 Mbps
B. 20 Mbps
C. 30 Mbps
D. 40 Mbps
Answer» D. 40 Mbps
4.

The effective bandwidth of a telephone line being used for data transmission is

A. 30 Hz
B. 300Hz
C. 600Hz
D. 2400Hz
Answer» E.
5.

The loss in signal power as light travels down the fiber is called ...............

A. attenuation
B. propagation
C. scattering
D. interruption
Answer» B. propagation
6.

Avalanche photodiode receivers can detect bits of transmitted data by receiving

A. 100 photons
B. 200 photons
C. 2000 photons
D. 300 photons
Answer» C. 2000 photons
7.

Which ISDN plane is associated with signaling another D channel?

A. user
B. control
C. management
D. supervise
Answer» B. control
8.

Multipath fading .................. the signal.

A. enhances
B. adds to
C. cancels
D. maximizes
Answer» D. maximizes
9.

A television broadcast is an example of ....................... transmission.

A. Simplex
B. half-duplex
C. full-duplex
D. automatic
Answer» B. half-duplex
10.

Which of the following is considered a broad band communication channel?

A. coaxial cable
B. fiber optics cable
C. microwave circuits
D. all of the above
Answer» E.
11.

Which of the following is not a transmission medium?

A. telephone lines
B. coaxial cables
C. modem
D. microwave systems
Answer» D. microwave systems
12.

In ................... transmission, the channel capacity is shared by both communicating devices at all times.

A. simplex
B. half-duplex
C. full-duplex
D. automatic
Answer» D. automatic
13.

The receive equalizer reduces delay distortions using a ...............

A. tapped delay lines
B. gearshift
C. descrambler
D. difference engine
Answer» B. gearshift
14.

In computer, communication media includes

A. standard telephone lines
B. coaxial cables
C. microwave transmission
D. all of these
Answer» E.
15.

................. is a measure of how much the strength of the signal is reduced in passing through a medium.

A. Attenuation
B. Amplification
C. Bandwidth
D. Frequency
Answer» B. Amplification
16.

In Discrete Multitone Technique (DMT), Channel 1-5 is used for

A. idle position
B. voice communication
C. data communication
D. error detection
Answer» B. voice communication
17.

In OOOVBOVB, V stands for violation and B stands for

A. Bit
B. Baud
C. Bandwidth
D. Bipolm
Answer» E.
18.

A switch connects several local loops or trunks and allows a connection between different

A. switches
B. loops
C. trunks
D. subscribers
Answer» E.
19.

The omnidirectional antennas send out signals in

A. one direction
B. 2 directions
C. no direction
D. all directions
Answer» E.
20.

In a constellation diagram, a signal element type is represented as a

A. Dot
B. line
C. x component
D. y component
Answer» B. line
21.

The distance of the Symmetric Digital Subscriber Line (SDSL) is

A. 18000
B. 12000
C. 10000
D. 30000
Answer» C. 10000
22.

The agreement between the communicating devices are called

A. Data
B. Message
C. Protocol
D. Transmission Medium
Answer» D. Transmission Medium
23.

The term that refers to as mBlnB coding, it replaces each m bit group with an n bit group is called

A. Multilevel technique
B. Polar techniques
C. Scrambling technique
D. block coding scheme
Answer» E.
24.

The example of an analog to analog conversion is

A. radio
B. Video
C. Television
D. internet
Answer» B. Video
25.

Hybrid network includes combination of

A. Nodes
B. Devices
C. topologies
D. None of the above
Answer» D. None of the above
26.

The term that means data is sent over four wires at the same time is

A. 4S
B. 4D
C. 4W
D. 4R
Answer» C. 4W
27.

The 8BIlOB block coding is a combination of

A. 5B/6B and 3B/3B
B. 5B/6B and 3B/4B
C. 5B/6B and 4B/4B
D. 4B/5B and 3B/4B
Answer» C. 5B/6B and 4B/4B
28.

Parallel transmission is good in speed but it is very

A. cheap
B. costly
C. time consuming
D. Both b and c
Answer» C. time consuming
29.

Microwaves transmission, coaxial cables and fiber optics are examples of

A. modems
B. routers
C. transmission media
D. ring networks
Answer» D. ring networks
30.

Which of the following severally affects the quality of satellite transmission?

A. bad weather
B. mountains
C. light rays
D. Moon
Answer» B. mountains
31.

Path through which computer data is transmitted from one place to another is called

A. communication media
B. transmission media
C. channel
D. all of these
Answer» E.
32.

Important property of fiber optic cable is

A. noise
B. reflection
C. interference
D. attenuation
Answer» C. interference
33.

The telephone network is made of ______ major components.

A. 2
B. 3
C. 4
D. 5
Answer» C. 4
34.

Time taken by a computer data signal to reach to moon and then back to earth is about

A. 2 minutes
B. 2 seconds
C. 2 ms
D. 2 hours
Answer» C. 2 ms
35.

Cable which is comprised of two separate insulated copper wires that are twisted together is called

A. fiber optics
B. twisted pair cable
C. microwave
D. coaxial cable
Answer» C. microwave
36.

Communication medium which requires line-of-sight is

A. microwave
B. fiber optic cable
C. twisted pair cable
D. coaxial cable
Answer» B. fiber optic cable
37.

Which of the following is not a communication media?

A. twisted pair
B. UTP
C. microwave
D. modem
Answer» E.
38.

The B-channel is capable of carrying both

A. Voice
B. Data
C. Both a & b
D. None of these
Answer» D. None of these
39.

Transmission media which consists of thin glass to transmit beams of light is

A. twisted pair
B. coaxial cable
C. fiber optics cable
D. satellite
Answer» D. satellite
40.

The second generation of cable networks is called a(n) _________ network.

A. HFC
B. HCF
C. CFH
D. none of the above
Answer» B. HCF
41.

The traditional cable TV system used ________cable end to end.

A. twisted-pair
B. coaxial
C. fiber-optic
D. none of the above
Answer» C. fiber-optic
42.

To use a cable network for data transmission, we need two key devices: a ______ and a _________.

A. CM; CMS
B. CT; CMTS
C. CM; CMTS
D. none of the above
Answer» D. none of the above
43.

The two most common digital services are ________ service and ______.

A. switched/56; switched/64
B. switched/56; DDS
C. DDS; swiched 64
D. leased; out-of-band
Answer» C. DDS; swiched 64
44.

The HFC network uses _______ cable.

A. twisted-pair
B. coaxial
C. fiber-optic
D. a combination of (b) and (c)
Answer» E.
45.

Telephone companies provide two types of analog services: analog _______ services and analog _____services.

A. switched; in-band
B. out-of-band; in-band
C. switched; leased
D. leased; out-of-band
Answer» D. leased; out-of-band
46.

______technology is a set of technologies develpoed by the telephone companies to provide high data rate transmission.

A. ASL
B. DSL
C. LDS
D. none of the above
Answer» C. LDS
47.

Most popular modems available are based on the ________standards.

A. V-series
B. X-series
C. VX-series
D. none of the above
Answer» B. X-series
48.

The term modem is a composite word that refers to the two functional entities that make up the device: a signal _______ and a signal _______.

A. modulator; demodulator
B. demodulator; modulator
C. modern; demo
D. none of the above
Answer» B. demodulator; modulator
49.

_______ is suitable for businesses that require comparable upstream and downstream data rates.

A. VDSL
B. ADSL
C. SDSL
D. both (a) and (b)
Answer» D. both (a) and (b)
50.

This is ordinary telephone twisted pair wire, one of several physical media specified in the IEEE 802.3 standard for Ethernet local area networks (LANs).

A. 10BASE-T
B. 10BASE-F
C. 5BASE-T
D. 100BASE-T
Answer» B. 10BASE-F