Explore topic-wise MCQs in Engineering.

This type of axonometric drawing has equal foreshortening along two axis directions and a different amount on the third axis:

These weld symbols have no arrow-side or other-side significance:

In these drawings it is necessary to show cut surfaces and distinguish between adjacent parts:

These drawings are given to contractors to perform work or manufacture individual parts:

This should show what changes were made, when, and by whom:

Some of the common terms used to describe technical drawing include:

The View toolbar will position the view of the 3-D solid toward the ________.

The default position of the UCS icon is positioned at ________ on the AutoCAD grid.

Developing the foundation plan is probably the starting point for creating a set of architectural plans.

A typical set of architectural working drawings would probably include floor plans, foundation plans, elevations, section details, and roof framing plans.

AutoCAD's Design Center is used to manage various block libraries used in architectural drawings.

Elevation views generally include the front, right side, back, and left side views.

Blocks are not an important element of architectural drawings.

The floor plan is a bird's eye view of the house.

If the roof pitch for a house is identified as 5/12 the height of the roof rises 2 " for every 14" of horizontal run.

A set of working drawings used to build a house is considered a legal document.

Although the drafter creates the working drawings, the accuracy of the set of drawings is most often the responsibility of the design architect.

The top, front, and bottom views align in this manner:

The organized and orderly approach to solving problems is known as the:

The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.

Scale is stated as a ratio of the number of drawing units to the number of actual units.

Students can complete an associate's degree in drafting which normally takes about ________ years to complete.

The Cutting Plane line reveals the type of material that the object is to be made from.

A section-lined area is always completely bounded by a visible outline.

Specific tolerances are based on the part's function and fit.

Isometric drawings are often used by ________ to help illustrate complex designs.

When a finished part is measured, it may vary slightly from the exact dimension specified.

These are accurately drawn maps of cities and towns showing property lines and other features that control property ownership:

The Offset command can be used on vertical lines but not on horizontal lines.

When inserting a block into a drawing the drafter can easily change the scale to match a particular scale factor for the drawing.

BOM stands for Bill of Materials.

Mechanical drafters can revise any drawing at any time without tracking those changes.

The symbols used on electrical plans represent the standard equipment used in homes and commercial buildings.

An accurate record of changes made to released drawings is tracked via this:

Nonisometric lines are equally foreshortened.

Only vertical lines behind the picture plane are foreshortened.

The first step in creating a traditional technical drawing is to ________.

Drafters are often expected to follow the drafting standards as set in the ASME Y14.5M-1994 publication.

The angle of revolution should always be less than 45 degrees for an aligned section.

The bearing of a line is its angle from magnetic south.

Several of the tools used in traditional drafting include the following:

Before starting an isometric drawing in AutoCAD the drafter needs to ________.

An isometric drawing is a type of technical drawing used to illustrate a mechanical part in true 3-dimensional form.

Problem identification has to do with the final stages in the mechanical design process.

The Press-Pull tool will ________ the face of a solid model in the direction it faces.

Traditionally, design and manufacturing activities have taken place in sequential order.

Connecting lines for conductors are typically drawn horizontally or vertically to minimize bends and crossovers.

Isometric drawings have equal foreshortening along each of the three axis directions.

Nautical maps and charts show prominent landmarks used for air navigators.

Terminals or leads are frequently identified by colors or symbols, which should be indicated on the diagram.