MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 8 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering Drawing knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
In which system of dimensioning the figures can read from the bottom only? |
| A. | Aligned system |
| B. | Unidirectional system |
| C. | Nonaligned multidirectional system |
| D. | Parallel system |
| Answer» C. Nonaligned multidirectional system | |
| 2. |
In unidirectional system, the figures are written along the dimension line. |
| A. | True |
| B. | False |
| Answer» C. | |
| 3. |
While dimensioning, what should always be written before a point accompanied by a figure if the value of the figure is less than unity? |
| A. | 1 |
| B. | 0 |
| C. | 2 |
| D. | 6 |
| Answer» C. 2 | |
| 4. |
What is the height if the dimension figures written on the dimension line? |
| A. | 7mm to 9mm |
| B. | 2mm to 3mm |
| C. | 6mm to 8mm |
| D. | 3mm to 5mm |
| Answer» E. | |
| 5. |
While dimensioning holes, slots, etc. how would their number be specified? |
| A. | Number written on the dimension line |
| B. | Number is written of the leader line |
| C. | Number is written on the corner of page |
| D. | Number is written on the side of the hole or slot |
| Answer» B. Number is written of the leader line | |
| 6. |
While dimensioning a circle, the leader line and the dimension line are drawn at which angle with respect to each other? |
| A. | 45 |
| B. | 30 |
| C. | 0 or 180 |
| D. | 90 |
| Answer» D. 90 | |
| 7. |
When dimensioning the circle, the dimension line begins from the center of the circle. |
| A. | True |
| B. | False |
| Answer» B. False | |
| 8. |
In dimensioning, the lines enclosing the dimension line are known as ____ |
| A. | Leader line |
| B. | Dimension line |
| C. | Extension line |
| D. | Outline |
| Answer» D. Outline | |