While dimensioning holes, slots, etc. how would their number be specif – McqOptions

MCQOPTIONS

1.	While dimensioning holes, slots, etc. how would their number be specified?
A.	Number written on the dimension line
B.	Number is written of the leader line
C.	Number is written on the corner of page
D.	Number is written on the side of the hole or slot
Answer» B. Number is written of the leader line

Discussion

No Comment Found

Related MCQs

In which system of dimensioning the figures can read from the bottom only?
In unidirectional system, the figures are written along the dimension line.
While dimensioning, what should always be written before a point accompanied by a figure if the value of the figure is less than unity?
What is the height if the dimension figures written on the dimension line?
While dimensioning holes, slots, etc. how would their number be specified?
While dimensioning a circle, the leader line and the dimension line are drawn at which angle with respect to each other?
When dimensioning the circle, the dimension line begins from the center of the circle.
In dimensioning, the lines enclosing the dimension line are known as ____