Explore topic-wise MCQs in Electrical Engineering Questions.

This section includes 18 Mcqs, each offering curated multiple-choice questions to sharpen your Electrical Engineering Questions knowledge and support exam preparation. Choose a topic below to get started.

1.

When a Wheatstone bridge is in a balanced condition, the center voltmeter in the bridge will read_____________?

A. twice the source voltage
B. half the source voltage
C. zero volts
D. the same as the source voltage
Answer» D. the same as the source voltage
2.

Two 3.3 kΩ resistors are in series and this series combination is in parallel with a 4.7 kΩ resistor. The voltage across one of the 3.3 kΩ resistors is 12 V. The voltage across the 4.7 kΩ resistor is_________?

A. 24 V
B. 12 V
C. 0 V
D. 6 V
Answer» B. 12 V
3.

Two 1.2 kΩ resistors are in series and this series combination is in parallel with a 3.3 kΩ resistor. The total resistance is____________?

A. 138 Ω
B. 1,389 Ω
C. 5,700 Ω
D. 880 Ω
Answer» C. 5,700 Ω
4.

Three 10 kΩ resistors are connected in series. A 20 kΩ resistor is connected in parallel across one of the 10 kΩ resistors. The voltage source is 24 V. The total current in the circuit is___________?

A. 900 μA
B. 9 mA
C. 90 mA
D. 800 μA
Answer» B. 9 mA
5.

The positive (+) and negative (-) ends of the battery are called ___________?

A. circuit diagram
B. battery knobs
C. battery terminals
D. battery sides
Answer» D. battery sides
6.

The parallel combination of a 470 Ω resistor and a 680 Ω resistor is in series with the parallel combination of four 2 kΩ resistors. The total resistance is___________?

A. 1,650 Ω
B. 1,078 Ω
C. 77.8 Ω
D. 778 Ω
Answer» E.
7.

The parallel combination of a 470 Ω resistor and a 1.2 kΩ resistor is in series with the parallel combination of three 3 kΩ resistors. A 200 V source is connected across the circuit. The resistor with the most current has a value of____________?

A. 470 Ω or 1.2 kΩ
B. 3 kΩ
C. 470 Ω
D. 1.2 kΩ
Answer» D. 1.2 kΩ
8.

The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)___________?

A. 6.8 kΩ
B. 2.2 kΩ
C. 6.8 kΩ and 10 kΩ
D. 2.2 kΩ and 1 kΩ
Answer» D. 2.2 kΩ and 1 kΩ
9.

The parallel combination of a 470 Ω resistor and a 1.5 kΩ resistor is in series with the parallel combination of five 1 kΩ resistors. The source voltage is 50 V. The percentage of the load current through any single 1 KΩ resistor is__________?

A. 25 %
B. 20 %
C. 100 %
D. 50 %
Answer» C. 100 %
10.

The internal resistance of a 20,000 ohm/volt voltmeter set on its 5 V range is_____________?

A. 20,000 Ω
B. 100,000 Ω
C. 200,000 Ω
D. 1,000,000 Ω
Answer» C. 200,000 Ω
11.

The first goal to accomplish in analyzing a complex series-parallel circuit is to____________?

A. solve for all the voltage drops
B. solve for the total current and resistance
C. equate all series components
D. equate all parallel components
Answer» C. equate all series components
12.

The current flowing through an unloaded voltage divider is called the____________?

A. bleeder current
B. load current
C. resistor current
D. voltage current
Answer» B. load current
13.

In a series–parallel circuit consisting of R1 and R2 in series and connected in parallel with R3, if R1 opens, then R2‘s voltage will:___________?

A. increase
B. remain the same
C. decrease
D. cannot tell
Answer» D. cannot tell
14.

In a series–parallel circuit, individual component power dissipation are calculated using_____________?

A. individual component parameters
B. a percent of the total power depending on resistor ratios
C. total current squared multiplied by the resistor values
D. a percent of the voltage division ratio squared
Answer» B. a percent of the total power depending on resistor ratios
15.

In a certain five-step R/2R ladder network, the smallest resistor value is 1 kΩ. The largest value is___________?

A. Indeterminable
B. 2 kΩ
C. 10 kΩ
D. 20 kΩ
Answer» C. 10 kΩ
16.

A Wheatstone bridge can be used to determine an unknown_____________?

A. current
B. voltage
C. resistance
D. power
Answer» D. power
17.

A voltage divider consists of two 68 kΩ resistors and a 24 V source. The unknown output voltage is______________?

A. 12 V
B. 24 V
C. 0 V
D. 6 V
Answer» B. 24 V
18.

A device able to supply electrical energy is a __________?

A. nonconductor
B. battery
C. conductor
D. microwave
Answer» C. conductor