Explore topic-wise MCQs in Chemical Engineering.

This section includes 71 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.

1.

With increase in the discounted cash flow rate of return, the ratio of the total present value to the initial investment of a given project ?

A. Decreases
B. Increases
C. Increases linearly
D. Remain constant
Answer» B. Increases
2.

Which of the following is not a component of the fixed capital for a chemical plant facility ?

A. Raw materials inventory
B. Utilities plants
C. Process equipment
D. Emergency facilities
Answer» B. Utilities plants
3.

‘Utilities’ in a chemical process plant includes compressed air, steam, water, electrical power, oxygen, acetylene, fuel gases etc. Utility costs for ordinary chemical process plants ranges roughly from _______________ percent of the total product cost?

A. 1 to 5
B. 10 to 20
C. 25 to 35
D. 35 to 45
Answer» C. 25 to 35
4.

Utilities cost in the operation of chemical process plant comes under the ?

A. Plant overhead cost
B. Fixed charges
C. Direct production cost
D. General expenses
Answer» D. General expenses
5.

Total product cost of a chemical plant does not include the ______________ cost?

A. Market survey
B. Operating labour, supervision and supplies
C. Overhead and utilities
D. Depreciation, property tax and insurance
Answer» B. Operating labour, supervision and supplies
6.

The total investment in a project is Rs. 10 lakhs and the annual profit is 1.5 lakhs. If the project life is 10 years, then the simple rate of return on investment is__________________?

A. 15%
B. 10%
C. 1.5%
D. 150%
Answer» D. 150%
7.

The ‘total capital investment’ for a chemical process plant comprises of the fixed capital investment and the_________________?

A. Overhead cost
B. Working capital
C. Indirect production cost
D. Direct production cost
Answer» C. Indirect production cost
8.

The ratio of working capital to total capital investment for most chemical plants (except for non-seasonal based products) is in the range of _____________ percent ?

A. 0.1 to 1
B. 1 to 2
C. 10 to 20
D. 50 to 60
Answer» D. 50 to 60
9.

The ratio of gross annual sales to the fixed capital investment is termed as the ________________ ratio?

A. Cash reserve
B. Capital
C. Turnover
D. Investment
Answer» D. Investment
10.

The payback method for the measurement of return on investment___________________?

A. Gives a correct picture of profitability
B. Underemphasises liquidity
C. Does not measure the discounted rate of return
D. Takes into account the cash inflows after the recovery of investments
Answer» D. Takes into account the cash inflows after the recovery of investments
11.

The ______________ of a chemical company can be obtained directly from the balance sheet as the difference between current assets and current liabilities ?

A. Cash ratio
B. Net working capital
C. Current ratio
D. Liquids assets
Answer» C. Current ratio
12.

The inventory of raw materials included in the working capital is usually about ______________ month‟s supply of raw materials valued at delivery prices?

A. One
B. Three
C. Six
D. Twelve
Answer» B. Three
13.

The economic life of a large chemical process plant as compared to a small chemical plant is_______________?

A. Only slightly more
B. Much more
C. Slightly less
D. Almost equal
Answer» C. Slightly less
14.

The depreciation during the year ‘n’, in diminishing balance method of depreciation calculation, is calculated by multiplying a fixed percentage ‘N’ to the ?

A. Initial cost
B. Book value at the end of (n – 1)th year
C. Depreciation during the (n – 1)th year
D. Difference between initial cost and salvage value
Answer» C. Depreciation during the (n – 1)th year
15.

The amount of simple interest during ‘n’ interest period is (where, i = interest rate based on the length of one interest period, p = principal) ?

A. p.i.n.
B. p(1 + i.n)
C. p(1 + i)n
D. p(1 – i.n)
Answer» B. p(1 + i.n)
16.

The amount of compounded interest during ‘n’ interest periods is_________________?

A. p[(1+i)n – 1)]
B. p(1 + i)n
C. p(1 – i)n
D. p(1 + in)
Answer» B. p(1 + i)n
17.

Scheduling provides information about the_________________?

A. Proper utilisation of machines
B. Means to minimise idle time for machines
C. Time of completion of job
D. Time of starting of job and also about how much work should be completed during a particular period
Answer» E.
18.

Relative cost of chemical process plants in India is about ______________ percent more than the similar plants in U.S.A ?

A. 15
B. 35
C. 55
D. 75
Answer» C. 55
19.

Purchased cost of equipments for a chemical process plant ranges from _____________ percent of the fixed capital investment?

A. 10 to 20
B. 20 to 40
C. 45 to 60
D. 65 to 75
Answer» C. 45 to 60
20.

Personnel working in the market research group is responsible for the job of__________________?

A. Equipment selection
B. Product evaluation
C. Equipment design
D. Cost estimation
Answer» C. Equipment design
21.

Payback period____________________?

A. And economic life of a project are the same
B. Is the length of time over which the earnings on a project equals the investment
C. Is affected by the variation in earnings after the recovery of the investment
D. All A, B. and C
Answer» C. Is affected by the variation in earnings after the recovery of the investment
22.

‘P’ is the investment made on an equipment, ‘S’ is its salvage value and ‘n is the life of the equipment in years. The depreciation for Rath year by the sum-of year‟s digit method will be____________________?

A. (P – S)/n
B. 1 – (P/S)1/m
C. (m/n) (P – S)
D. [2 (n – m + 1)/n(n + 1)]. (P – S)
Answer» E.
23.

Out of the following, the depreciation calculated by the _____________ method is the maximum?

A. Diminishing balance
B. Straight line
C. Sum of the years digit
D. Sinking fund
Answer» B. Straight line
24.

Optimum number of effects in a multiple effect evaporator is decided by the____________________?

A. Cost benefit analysis
B. Floor area availability
C. Terminal parameters
D. Evaporation capacity required
Answer» B. Floor area availability
25.

Optimum economic pipe diameter for fluid is determined by the___________________?

A. Viscosity of the fluid
B. Density of the fluid
C. Total cost considerations (pumping cost plus fixed cost of the pipe)
D. None of these
Answer» D. None of these
26.

Operating profit of a chemical plant is equal to___________________?

A. Profit before interest and tax i.e., net profit + interest + tax
B. Profit after tax plus depreciation
C. Net profit + tax
D. Profit after tax
Answer» B. Profit after tax plus depreciation
27.

________________ of depreciation calculation does not take into account the interest on investments?

A. Present worth method
B. Sinking fund method
C. Sum of the years-digits method
D. All A, B. and C.
Answer» D. All A, B. and C.
28.

_________________ of depreciation calculation accounts for the interest on investment?

A. Straight line method
B. Declining balance
C. Both A. and B.
D. Neither A. nor B.
Answer» E.
29.

Nominal and effective interest rates are equal, when the interest is compounded______________?

A. Quarterly
B. Semi-annually
C. Annually
D. In no case, they are equal
Answer» D. In no case, they are equal
30.

Most chemical plants use an initial working capital amounting to 10-20% of the total capital investment. But this percentage may increase to ______________ percent in case of seasonal products manufacturing plant?

A. 30
B. 50
C. 75
D. 95
Answer» C. 75
31.

_____________ method for profitability evaluation of a project does not account for investment cost due to land ?

A. Net present worth
B. Pay out period
C. Discounted cash flow
D. Rate of return on investment
Answer» C. Discounted cash flow
32.

Manufacturing cost in a chemical company does not include the____________________?

A. Fixed charges
B. Plant overheads
C. Direct products cost
D. Administrative expenses
Answer» E.
33.

‘Lang factor’ is defined as the ratio of the capital investment to the delivered cost of major equipments. The value of ‘Lang factor’ for fixed capital investment, for a solid-fluid processing chemical plant ranges from ?

A. 1.2 to 1.4
B. 2.5 to 2.7
C. 4.2 to 4.4
D. 6.2 to 6.4
Answer» D. 6.2 to 6.4
34.

In financial accounting of a chemical plant, which of the following relationship is invalid ?

A. Assets = equities
B. Assets = liabilities + net worth
C. Total income = costs + profits
D. Assets = capital
Answer» E.
35.

In declining balance method of depreciation calculation, the _____________________?

A. Value of the asset decreases linearly with time
B. Annual cost of depreciation is same every year
C. Annual depreciation is the fixed percentage of the property value at the beginning of the particular year
D. None of these
Answer» D. None of these
36.

In an ordinary chemical plant, electrical installation cost may be about ____________________?

A. 10-15% of purchased equipment cost
B. 3-10% of fixed capital investment
C. Either A. or B.
D. Neither A. nor B.
Answer» D. Neither A. nor B.
37.

In a manufacturing industry, breakeven point occurs, when the___________________?

A. Total annual rate of production equals the assigned value
B. Total annual product cost equals the total annual sales
C. Annual profit equals the expected value
D. Annual sales equals the fixed cost
Answer» C. Annual profit equals the expected value
38.

In a chemical process plant, the total product cost comprises of manufacturing cost and the__________________?

A. General expenses
B. Overhead cost
C. R & D cost
D. None of these
Answer» B. Overhead cost
39.

If the interest rate of 10% per period is compounded half yearly, the actual annual return on the principal will be ______________ percent ?

A. 10
B. 20
C. > 20
D. < 20
Answer» D. < 20
40.

If ‘S’ is the amount available after ‘n’ interest periods for an initial principal ‘P’ with the discrete compound interest rate ‘i’, the present worth is given by__________________?

A. (1 + i)n/S
B. S/(1 + i)n
C. S/(1 + in)
D. S/(1 + n)i
Answer» C. S/(1 + in)
41.

If an amount R is paid at the end of every year for ‘n’ years, then the net present value of the annuity at an interest rate of i is _________________?

A. R [{(1 + i)n – 1}/ i ]
B. R [{(1 + i)n – 1}/ i (1 + i)n]
C. R(1 + i)n
D. R/(1 + i)n
Answer» C. R(1 + i)n
42.

Gross earning is equal to the total income minus___________________?

A. Total product cost
B. Fixed cost
C. Income tax
D. None of these
Answer» B. Fixed cost
43.

Generally, income taxes are based on the____________________?

A. Total income
B. Gross earning
C. Total product cost
D. Fixed cost
Answer» C. Total product cost
44.

Functional depreciation of an equipment is the measure of decrease in its value due to its _________________?

A. Ageing
B. Wear and tear
C. Obsolescence
D. Breakdown or accident
Answer» D. Breakdown or accident
45.

For a given fluid, as the pipe diameter increases, the pumping cost ______________________?

A. Decreases
B. Increases
C. Remains the same
D. May increase or decrease, depending upon whether the fluid is Newtonian or non-Newtonian
Answer» B. Increases
46.

Following the six-tenth factor rule, if a log-log plot of capacity of the equipment vs. cost of the equipment is made, then a straight line is obtained, whose slope is equal to_________________?

A. 0.1
B. 0.6
C. 0.2
D. 0.8
Answer» C. 0.2
47.

Fixed charges for a chemical plant does not include the____________________?

A. Interest on borrowed money
B. Rent of land and buildings
C. Property tax, insurance and depreciation
D. Repair and maintenance charges
Answer» E.
48.

Factory manufacturing cost is the sum of the direct production cost_________________?

A. Fixed charges and plant overhead cost
B. And plant overhead cost
C. Plant overhead cost and administrative expenses
D. None of these
Answer» B. And plant overhead cost
49.

Equipment installation cost in a chemical process plant ranges from _______________ percent of the purchased equipment cost ?

A. 10 to 20
B. 35 to 45
C. 55 to 65
D. 70 to 80
Answer» C. 55 to 65
50.

Effluent treatment cost in a chemical plant is categorised as the __________________ cost?

A. Fixed
B. Overhead
C. Utilities
D. Capital
Answer» D. Capital